Hasselblad Flextight 343 Manuel d'utilisateur télécharger pdf (Page 18)

6. The light tube is clearly visible, as shown in Figure 7. Hold each end

of the light tube between your thumb and index finger. Rotate the

light tube until it comes free and pull it away from the scanner. Note

that the light tube sockets allow the tube to be rotated all the way

around, but they click into position at each quarter turn. The light

tube is locked in place in all but one of these four positions, so you

may need to try up to three positions before the light tube comes

free.

7. Install a new light tube following the reverse of the procedure you

used when removing it. Make sure the sleeve is aligned correctly

with the scanner as shown in Figure 5. Rotate the light tube and/or

adjust the sleeve as necessary.

8. Replace the bottom panel by holding it in place and tightening the

screws in an opposite-diagonal sequence (e.g. top-left, bottom-right,

top-right, bottom-left) as indicated in Figure 6.

9. Turn on the scanner and check function of the new tube.

User's Guide - Flextight 343

Hardware Reference - Flextight 343

The Light Tube

English

Feed Table (closed)

Light Tube

The holes in the light tube

sleeve must point forwards,

towards the feed table.

Figure 7: Bottom view of the scanner with the bottom panel removed

1 2 ... 13 14 15 16 17 18 19 20 21 22

Pas de commentaire

Hasselblad Flextight 343 Manuel d'utilisateur Page 18